Below is a template for completing the statement of water diversion use at www.waterboards.ca.gov/rms for flow measured with the Wildeye "standard" depth gauge, accuracy +-2in.
| Water Right ID S000000<Insert your Water Right ID> |
Diverter of Record WILDEYE FARMS INC<Insert your diverter of record> |
MEASURING DEVICE / MEASUREMENT METHOD INFORMATION
Attachments: additional documentation related to the measurement device or method should be attached to the water use report. You will be able to add attachments before submitting the completed report.
| M1. | Briefly describe the measurement device or method: | Submersible pressure transducer |
| M2. | Nickname of measurement device/method (example: pump 1): |
"i.e. Dwyer Level Transducer" |
| M3. | Type of device / method: | |
| M4. | Device make: | Dwyer |
| M5. | Serial number: | N/A |
| M6. | Model number: | SBLT2/MBLT |
| M7. | Approximate date of installation: | (mm/dd/yyyy, example: 02/07/2009) |
| M8. | Additional info: |
MEASURING DEVICE / MEASUREMENT METHOD ACCURACY
| M9. | Approximate date the measuring device was last calibrated or the measurement method was updated: |
Request date from Wildeye when the device was last "air" calibrated. Example: Pressure gauge attached to OP01234, calibrated 07/14/2017 |
| M10. | Estimated accuracy of measurement: |
SBLT2-V-D32F-C59F "+/-1 in accuracy" MBLT-V-D98F-C118F "+/-3 in accuracy" |
| M11. | Description of calibration method: | Offset calibration against weight of "air", ie calibrate to 0 water height. |
| M12. | Describe the maintenance schedule for the device/method: | Periodic inspections check sensor readout is within +-1in of staff gauge |
| PROVIDE THE FOLLOWING INFORMATION FOR THE PERSON WHO LAST CALIBRATED THE DEVICE OR DESIGNED THE MEASUREMENT METHOD: | |||||||
| M13. | Name: | Last calibrated by: Megan Tucker | |||||
| M14. | Phone number: |
(559)464-8300 |
|||||
| M15. | Email: | ||||||
| M16. | Qualificationsof the individual: |
|
|||||
| M17. |
Provide license number and type for the qualified individual above and/or any other relevant explanation: Bachelors of Agricultural Engineering, |
||||||
DATA RECORDER INFORMATION
| M18. | Type of device / method: | |
| M19. | Device make: | Wildeye |
| M20. | Serial number: | OP00000 (note the "OP" number on the side of the wildeye device) |
| M21. | Model number: | WILD-E-L-MA |
| M22. | Units of measurement: | inches Cubic Feet Gallons |
| M23. | Frequency of data recording: | More frequent than hourly Hourly Daily Weekly Monthly |
| M24. | Additional info: |
TELEMETRY INFORMATION
| M25. |
|
|||
| M26. | I report my diversion or storage date by telemetry to the following website: www.mywildeye.com | |||
CALCULATING VOLUME FROM RECORDED DATA
If your measuring device measures a flow rate, water velocity, or water elevation, attach a rating table or description of the method used to convert the measured value into a volume of water.
| M27. | I have attached additional information on the method I used to calculate the volume of water. not required for flow meter |
ATTACHED DOCUMENTS
| M28. | Describe any documents related to this measurement device or method that are attached to this water use report: |