Adding a Soil Moisture Sensor

Requirements: 

• Wildeye logger with an "S" in the product code i.e. WILD-E-R-NACS-NACS
• Soil Moisture Probe 

Configuration:

1. Login to Wildeye 
2. Click on the sites tab at the top of the screen.
3. Locate the site that you want to add a soil moisture sensor to and click on it's wrench icon  on the right hand side of the window.
4. Click the "Add Sensor" Button
5. Start typing in the name of the soil moisture sensor or the sensor product code, eg "Enviropro" or "ACC-SEN-EP100G-40"
   
6. Click on the "Use" button 
7. Select the neccessary drop-downs to fit your requirements
   • SDI12 Address: This is a predetermined number that the sensor is set to
     • All sensors are preset by factories as "0" 
   • Logging interval (min): Logging should be set to 15 minutes 
     • For full length probes logging should not be set faster than 15 minutes 
   • Number of levels: This is a preset number on the probe and should be adjusted to fit the specifications of the probe itself
     • EnviroPro
       • 16" = 40cm = 4 sensors
       • 32" = 80cm = 8 sensors 
       • 48" = 120cm = 12 sensors
       • 64" = 160cm = 16 sensors
     • Sentek 
       • 12" = 30cm = 3 sensors
       • 24" = 60cm = 6 sensors
       • 36" = 90cm = 9 sensors
       • 48" = 120cm = 12 sensors
   • EC Included: This is a predetermined setting and the choice should be selected based on the specifications of the probe itself 
     • Note
       • EnviroPros can be remotely upgraded to EC using this link
       • Sentek Drill and drops can not be upgraded, they either have EC or do not
   • Same Soil Type at all levels: This is an option when knowing the soil type in the field ahead of time. 
   • Depth 1/all soil type: This can be adjusted to fit the soil profile
   • 
8. Click "Add Sensor to site"