Adding a Level Transducer

Requirements: 

• Wildeye logger with an "A" in the name i.e. WILD-E-R-MAC-MAS
• Pressure transducer  

Configuration:

1. Login Wildeye 
2. Click on the sites tab at the top of the screen.
3. Locate the site that you want to add a pressure transducer to and click on it's wrench icon  on the right hand side of the window.
4. Locate the button "Sensor" Button
5. 
6. Start typing in the manufacture of the transducer, or "water level"
7. Click the "Use" button
8. 
9. When selecting the drop downs 
   • Native vs ACC-EXP 
     • Native: This is the regular cable with no box 
     • ACC-EXP: This is a very unique cable with a small box that is inline with the cable that connects to the pressure transducer 
   • Pressure Sensor Model: Compare the part code from the order to select the correct sensor
   • <n> Pressure Sensor: This helps distinguish between cable 1 and cable 2 
   • Native 4-20mA input: The drop down will vary by name depending on the logger used. The choices will match what is listed under the "Native Inputs". i.e. if "Sensor Position 1" has a name of MAC 4-20mA, that name will apper as it does on the Native Inputs.
     • Note: When planning which cable you'll be attaching the pressure transducer, that is the side that will need to be configured. 
10. Click "Add Sensor to Site" 

Verify Readings: 

1. Press the test button till a solid blue light appears, wait for the green LED which means that the logger connected to the cloud 
2. Check the readings show close to zero
3. Insert the level transducer into a bucket with a tape measurement tool on the side 
4. Press the button, wait for it to turn green
5. Take a picture of the tape measurement and water level and send it to supportusa@mywildeye.com along with the op number